On : My Experience Explained

Useful Tips for How to Replace a Cutlass Bearing

A cutlass bearing is a bearing on a vessel’s drive shaft log that is commonly made using brass and a lining that is grooved from the inside which is lubricated by the water which enters the grooves during rotation, this.

After some time you must change the cutlass bearing regardless of how often you use your boat. When the time is up for changing the cutlass bearing, you will locate it a little off the keel or underneath the woodwork of the boat.

Fortunately apart from getting your hands dirty, removing the cutlass bearing is not tricky. Keep reading this article to know how to replace a cutlass bearing, now.

Locating and removing the set screws should be the first thing to do. The area where you will find the layer of crud and marine is where the set screws are hidden in most cases. Don’t forget that other boat manufacturers do not use set screws. If you notice your boat does not have the set screws then do not waste any more time looking for them.

During a cutlass bearing replacement you will be required to cut the bearing. In the absence of a Sawzall, you can use a hacksaw to cut the cutlass bearing. Using the Sawzall tool is something that requires you to have enough experience on how to use it.

Bending the cutlass bearing is the next step. With a cold chisel and a hammer, you can bend the cutlass bearing to the inside until you reach the place where you have made a cut. Avoid using a lot of force when hitting the cutlass bearing so that it can bend. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.

Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. By so doing you may damage the strut’s inside.

Finally, remove the cutlass bearing. Use a pair of pliers to hold the cutlass bearing to remove it. Now clean the surface of the strut and install a new cutlass bearing. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.

You will damage the strut’s ramrod if you push it and the line it is not straight. To ensure it goes in straight, apply some grease so that the cutlass bearing washer’s can easily slide in the strut.

Leave a Reply

Your email address will not be published. Required fields are marked *